Xtool X100 Pro2 change Porsche Cayenne 2010- odometer via OBD

Here's the quick guide on Porsche Cayenne 2010 up odometer correction using the xtool x100 pro2 via OBD in 3 minutes.

Mileage correction is so quick, simple and easy to do, and its all done via the OBD2 diagnostic port. You can also do key programming & EEPROM with the Xtool X100.

Original mileage: 105657 mile

Connect x100 pro2 with vehicle via OBD port

Select Dashboard->Europe->Porsche->Cayenne->2010 up ->Backup and mileage->Mile

Select New File

Enter new mileage you desired (i.e 400 mile) and confirm

Cummincating...
Mileage correction completed.

Check the new mileage on dashboard: 399 mile

You can also recover mileage. Select Recovery.

The mileage will be in original status.

xtool x100 pro 2 will correct mileage for following Porsche models:

911 918 996 997 Boxster Cayenne Cayman Panamera

X100 Pro2 will do mileage correction for other car brands:
Audi Buick Cadillac Chrysler Fiat Ford GMC Hummer Hyundai Kia Infiniti Jaguar Land Rover Mitsubishi Nissan Seat Skoda VW Pontiac Mercedes Ferrari Volvo Mazda Porsche But please check with the listing to make sure that your specific vehicle is covered.
http://www.obdii365.com/wholesale/xtool-x100-pro2-key-programmer.html

Program Nissan All Keys Lost with Xtool X100 Pad2

The guy lost their keys for the second time...and had already programmed a new key so when they found their old key it didn't work anymore...the key is a n101 transponder is a philips 46.
I’ve done a couple of micra k12 and qashqai standard keys with xtool x100 pad2. Done a couple of each worked ok. Reads bcm number and gives old and new pin. 

 

Select Immobilizer->Nissan/Infiniti->Read BCM code and release steering lock (4 pin code)->Read BCM code

Xtool pad2 read both new and old pin.

2008 and under models require old pin code... 2009 and up would be new pin code ..

Select Program Keys->Select from type->4 pincode->Type2 (CAN)

If not sure which type to choose, try them one by one

Turn on ignition switch and press OK to continue

Select Program Keys

Pin code is required to complete key programming.

Manually enter 4-digit pin code calculated above

Confirm PIN code

You have to complete the following procedure
1) Switch ignition off and remove key
2) Insert the 1st key and switch on for 5sec, then switch ignition off and remove key
3) If you want to add more keys, repeat same procedure until complete

 

Done.

www.obdii365.com

http://www.key-programmer.org/2020/04/08/xtool-x100-pad2-program-nissan-all-keys-lost/

Xtool X100 PAD2 Program Citroen C4 Picasso 2010 Remote Key

Citroen C4 Picasso 2010 added a new key successully using xtool x100 pad2.
Easy reads pin code with working key
Used key DIY remote ask 0523
Programed using type 1